jae_builds: (Default)
[personal profile] jae_builds
This stage was very satisfying in a way that was really hard to capture on camera. There were two (and a half) separate occasions where the title of this post happened. I'll point them out, but it was a very tactile experience, and photos just don't do it justice, so I'm sorry about that.

Here's the mise-en-place .


I started by building a piece to extend the black section of the hull.
The framework for another section of portholes. It's 15 studs long, and four studs wide for one half, and two studs wide for the other.
Black tiles have been placed on the framework.

The individual porthole assemblies have been placed on the black tiles.

I'm really enjoying how detailed and textured this section of the hull is, and how the sub-assemblies that make it up don't even really seem like hull sections until you put them into place, compared to the rest of the ship where the hull walls were just actual walls around a hollow box. This was the first "why is this shaped that way" moment; I didn't understand why it has the sticking-out bit, until I placed it on the main build and saw it in place.
The thinner section sits above a sloped block, creating the transition from the straight-walled section to the curve at the stern.

I built a mirror image of the same segment for the other side.
The other side of the ship, with a similar piece of hull wall attached.

Next I added the orange/gold plates to the top of the black section.
The sub-assemblies from the previous photos have been top with orange tiles, creating the thin gold line above the black hull section.
The orange plates have been extended towards the stern, and some triangular layered deck plates have been added.

Those tan triangular deck plates were the start of the second "Why is this shaped this way" moment, though the payoff would wait a bit. First I built some stair assemblies, and some more deck details.
Two 2x4 tan plates sitting on top of blue plates, and two stair assemblies, each of which consists of a staircase attached to a 1x4 block.
The stairs and deck plates have been added to the main build.

I added the base for the raised section of deck those stairs lead to, which is when those triangles went from "huh, that's an odd pattern of deck tiles" to making perfect sense and creating the shape of the aftcastle. (Also TIL the word "aftcastle" and I'm not sure it technically applies here but I don't know what else to call a raised section of deck near the stern. If you actually know boat words, please feel free to correct me in the comments.)
The triangular plates have been topped with triangular blocks, creating the central section of the aftcastle.

I added the hull walls surrounding the probably-not-actually-an-aftcastle.
A set of 1x2 white blocks with holes has been added on top of the orange plates, as well as a curved block near the end on each side, dropping the hull down to the lower section of deck.

I put deck tiles on the new section of deck. This was the third especially satisfying part; it didn't come with the moment of confusion the title describes, but placing these tiles, and especially the triangular ones, was very satisfying.
The raised section of deck has been covered in tan plates and tiles.

Then I wrapped up this stage by adding a railing to the hull.
1x4 bench pieces, as well as a few small plates, have been added on top of the white blocks with holes.

That's it for section 41! Only five more to go. Thanks as always for reading.

Discussion prompt: The multiple satisfying moments in this section were very good for soothing my overactive brain. What activities do you find soothing and calming?




Profile

jae_builds: (Default)
jae_builds

February 2022

S M T W T F S
  12345
6789101112
13 141516171819
20212223242526
2728     

Style Credit

Expand Cut Tags

No cut tags
Page generated Apr. 8th, 2026 10:22 am
Powered by Dreamwidth Studios